![]() Before powering on, do not plug in the power cord until you are ready. For instructions on configuring voice command settings for each application compatible with voice commands, refer to page 15 of the Ricoh Multifunction Printer Smart Operation Panel Settings manual. To discharge the power supply, turn off the device, unplug the power cord, and then press the main power button while holding it down until the LED flashes on and off. When setting print options using voice commands, verify that the settings are reflected on the Smart Operation Panel screen. The SOP firmware should only be installed after the SOP has been installed, preferably during the first power-up cycle. During our initial conversation with tech support, I was advised to update to the latest NOP firmware before installing my device. If connected normally, default setting icons will be displayed. Please note that the procedure outlined in the service manual is incorrect. To attach the Smart Operation Panel Type M3: 1. Refer to page 3 of the Operation Panel section for instructions. 2. Change the SP modes before modifying the operation panel. 3. Note that the Smart Operation Panel Type M3 is not an option for EU region devices. ![]() When changing screens (standard Android screen), refer to the Mainframe Firmware History document for additional information. Before installing the SOP or changing SP settings, ensure that your machine has all necessary firmware updates for the Smart Operation Panel version installed.
0 Comments
Leave a Reply. |